Signs on power line pole tips?

[whothesonsetsfreeisfree]

Probably not the right place for this post, but I been trying to put my 24” X 18” signs on powerline poles at 4 way intersections to drive up business and decrease the chances of my signs being stolen, however now im driving by seeing my signs getting bent up by the wind and was wondering if anyone else has had the same problem or found a solution as there is no point in me continuing to put them up if the wind is just gonna crease them to the point where people can only read half the sign.

 

[newmove]

@whothesonsetsfreeisfree Staple them to some pieces of 1x2 lumber.

 

[georgewaini]

@newmove Or run a wire through it.

 

[newmove]

@georgewaini Wires are flexible

 

[georgewaini]

@newmove Depends on what you got

 

[newmove]

@georgewaini You putting tungsten wires in your signs?

 

[georgewaini]

@newmove Bro just get the little metal frames that you use to stick the sign in the ground and run that through the signs

 

[amandabroken]

@whothesonsetsfreeisfree Get the wire that you stick it into the ground with and staple it sideways to the back of the sign, then staple the sign with big fat staples to the pole. problem solved